Welder SET AC/DC TIG 200A Pulse With Plasma Cutter Gloves Welding Helmet Apron Armguard | NewYork 2500

NEW YORK 2500 FEATURES & BENEFITS:

• 3in1 combination unit: AC/DC TIG, MMA/STICK, plasma cutting.
  
• AC/DC TIG welding: processing of all weldable metals,including aluminum
  
• AdjustableAC output frequency allows the operator to focus the arc and minimize the heat-affected zone
• AdvancedAC balance control helps maintain a pointed tungsten needle to precisely control the arc in the weld joint.
  
• Pulse function: inPulse welding, the welding current alternates between output and peak current at the desired frequency. The longer the intervals, the less energy and heat is supplied to the workpiece.
• HF ignition (TIG )
  
• 2cycle/4cycle
• MMA/STICK/E-HAND: coated electrodes are used - in this process, the electrodes are arc carrier and filler metal in one.
• Hotstart: every time the welder is restarted, an overcurrent is provided to support the ignition of the arc.
  
• Arc-Force: molten material is more easily transferred to the workpiece, preventing the arc from being extinguished if this material causes contact between the electrode and the molten pool .
  
• Anti-stick: automatically shuts down the welding generator if the electrode sticks to the workpiece and must be removed manually without damaging the electrode clamp.
• Plasma cutter: CUT function using a plasma jet generated by electricity. This melts the material and removes it with compressed air - a precise cut is produced. This method can be used to cut all conductive metals (e.g. steel, stainless steel, aluminum, copper, etc.).
• cutting thickness: maximum 12mm (hand guided), quality cut 8mm (hand guided)
  
• advancedIGBT (InsulatedGate Bipolar Transistor) enables fast and thus low-loss switching of electrical currents
• job memory:the new york 2500 has9 memory locations

NEW YORK 2500 FEATURES:

NEW YORK 2500 TECHNICAL DETAILS:

NEW YORK 2500 SYSTEM CONTROL:

1. display	5. on/off	9. selection key
2. PULSE function	6. overheat indicator	10. hot start/arc force/anti stick
3. 2 beat/4 beat	7. JOB and SAVE	11. parameter settings
4. mode (MMA/WIG/CUT)	8. AC/DC mode

1. gas advance	5. secondary current	9. final current
2. start current	6. pulse width (%)	10. gas overrun
3rd current rise	7. pulse frequency (Hz)	11. AC frequency
4. welding current (primary)	8. current decrease	12. AC Balance